where ProView persons gather
You are not logged in.
Pages: 1
I've donde the updates calibrations over 7 times and the same problem appears, shaking and noises on the motor on normal shooting angles, not that extreme, what should I do?
Here is the video evidence
Offline
Hi ArtAbrego,
Please check out 3rd paragraph of ProView S3 Usage Notice: http://www.servicenavin.com/proviews3_f … c.php?id=4
Your video shows juddering and noise is due to maneuvering the gimbal holding at 45 degree, outside its intended operating modes of holding in upright (0 degree), upside-down (180 degree), and flashlight horizontal (90 degree) positions.
Although this might seem limiting, actually users can take videos shots without issue:
https://www.youtube.com/watch?v=doaqm2gydQk
Offline
Pages: 1