where ProView persons gather
You are not logged in.
Pages: 1
Got my S3 yesterday. It's splendid, but I have problem with the levelling while panning. It starts levelled and is so at 180°, but at a quarter lap at 90° the phone is tilted 10° and is so at 270° too.
I even mounted the S3 on a levelled tripod to make sure it's not due to tilting the handle. Check this out: https://youtu.be/1ds4c0PnH6U
Even if the levelling is wrong, shouldn't it always be the same? What's going on? Are you using magnetic fields which differs around the world? I live in Sweden.
Offline
Hi AnCa,
Have you done the 4 required steps mentioned in the Usage Notice before conducting this panning level test, http://www.servicenavin.com/proviews3_f … c.php?id=4 ?
Offline
I did them once when getting the device but now after recalibration and re-pairing the problem was gone! Great! Don't these settings survive a battery recharge? Glad it was solved though.
Offline
Hi AnCa,
Yes the settings are saved to Flash memory inside the gimbal, will be remembered after power off.
Offline
Pages: 1